| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
HID: playstation: Clamp num_touch_reports
A device would never lie about the number of touch reports would it?
If it does the loop in dualshock4_parse_report will read off the end of
the touch_reports array, up to about 2 KiB for the maximum number of 256
loop iteraions. The data that is read is emitted via evdev if the
DS4_TOUCH_POINT_INACTIVE bit happens to be set. Protect against this by
clamping the num_touch_reports value provided by the device to the
maximum size of the touch_reports array. |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: fix the out-of-bounds nameoff handling for trailing dirents
Currently we already have boundary-checks for nameoffs, but the trailing
dirents are special since the namelens are calculated with strnlen()
with unchecked nameoffs.
If a crafted EROFS has a trailing dirent with nameoff >= maxsize,
maxsize - nameoff can underflow, causing strnlen() to read past the
directory block.
nameoff0 should also be verified to be a multiple of
`sizeof(struct erofs_dirent)` as well [1].
[1] https://sashiko.dev/#/patchset/20260416063511.3173774-1-hsiangkao%40linux.alibaba.com |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: Fix slab-out-of-bounds read in DeleteIndexEntryRoot
In the 'DeleteIndexEntryRoot' case of the 'do_action' function, the
entry size ('esize') is retrieved from the log record without adequate
bounds checking.
Specifically, the code calculates the end of the entry ('e2') using:
e2 = Add2Ptr(e1, esize);
It then calculates the size for memmove using 'PtrOffset(e2, ...)',
which subtracts the end pointer from the buffer limit. If 'esize' is
maliciously large, 'e2' exceeds the used buffer size. This results in
a negative offset which, when cast to size_t for memmove, interprets
as a massive unsigned integer, leading to a heap buffer overflow.
This commit adds a check to ensure that the entry size ('esize') strictly
fits within the remaining used space of the index header before performing
memory operations. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Reset register ID for BPF_END value tracking
When a register undergoes a BPF_END (byte swap) operation, its scalar
value is mutated in-place. If this register previously shared a scalar ID
with another register (e.g., after an `r1 = r0` assignment), this tie must
be broken.
Currently, the verifier misses resetting `dst_reg->id` to 0 for BPF_END.
Consequently, if a conditional jump checks the swapped register, the
verifier incorrectly propagates the learned bounds to the linked register,
leading to false confidence in the linked register's value and potentially
allowing out-of-bounds memory accesses.
Fix this by explicitly resetting `dst_reg->id` to 0 in the BPF_END case
to break the scalar tie, similar to how BPF_NEG handles it via
`__mark_reg_known`. |
| SillyTavern is a locally installed user interface that allows users to interact with text generation large language models, image generation engines, and text-to-speech voice models. Prior to 1.18.0, SillyTavern accepts Remote-User (Authelia) and X-Authentik-Username (Authentik) HTTP headers to automatically log in users when SSO is configured. There is no validation that these headers originate from a trusted reverse proxy. Any network client that can reach the SillyTavern port directly can inject these headers and authenticate as any user, including administrators, without a password. This vulnerability is exploitable only when sso.autheliaAuth: true or sso.authentikAuth: true is set in config.yaml (both default to false). This vulnerability is fixed in 1.18.0. |
| Inappropriate implementation in ANGLE in Google Chrome prior to 148.0.7778.216 allowed a remote attacker to potentially perform out of bounds memory access via a crafted HTML page. (Chromium security severity: High) |
| Inappropriate implementation in Skia in Google Chrome on Android prior to 148.0.7778.216 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: Critical) |
| RabbitMQ is a messaging and streaming broker. From 3.7.0 to before 4.1.2 and 4.0.13, This vulnerability is fixed in 4.1.2 and 4.0.13. |
| A reflected cross-site scripting issue exists in URL handling. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: virtio_bt: validate rx pkt_type header length
virtbt_rx_handle() reads the leading pkt_type byte from the RX skb
and forwards the remainder to hci_recv_frame() for every
event/ACL/SCO/ISO type, without checking that the remaining payload
is at least the fixed HCI header for that type.
After the preceding patch bounds the backend-supplied used.len to
[1, VIRTBT_RX_BUF_SIZE], a one-byte completion still reaches
hci_recv_frame() with skb->len already pulled to 0. If the byte
happened to be HCI_ACLDATA_PKT, the ACL-vs-ISO classification
fast-path in hci_dev_classify_pkt_type() dereferences
hci_acl_hdr(skb)->handle whenever the HCI device has an active
CIS_LINK, BIS_LINK, or PA_LINK connection, reading two bytes of
uninitialized RX-buffer data. The same hazard exists for every
packet type the driver accepts because none of the switch cases in
virtbt_rx_handle() check skb->len against the per-type minimum HCI
header size before handing the frame to the core.
After stripping pkt_type, require skb->len to cover the fixed
header size for the selected type (event 2, ACL 4, SCO 3, ISO 4)
before calling hci_recv_frame(); drop ratelimited otherwise.
Unknown pkt_type values still take the original kfree_skb() default
path.
Use bt_dev_err_ratelimited() because both the length and pkt_type
values come from an untrusted backend that can otherwise flood the
kernel log. |
| A flaw was found in the X.Org X server. This vulnerability, an out-of-bounds read, affects the XKB (X Keyboard Extension) modifier map handling. An attacker with access to the X11 server can exploit this by sending a malformed request, which causes the server to read beyond its intended memory boundaries. This can lead to the exposure of sensitive information or cause the server to crash, resulting in a denial of service. |
| In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: fix oops when split header is enabled
For GMAC4, when split header is enabled, in some rare cases, the
hardware does not fill buf2 of the first descriptor with payload.
Thus we cannot assume buf2 is always fully filled if it is not
the last descriptor. Otherwise, the length of buf2 of the second
descriptor will be calculated wrong and cause an oops:
Unable to handle kernel paging request at virtual address ffff00019246bfc0
...
x2 : 0000000000000040 x1 : ffff00019246bfc0 x0 : ffff00009246c000
Call trace:
dcache_inval_poc+0x28/0x58 (P)
dma_direct_sync_single_for_cpu+0x38/0x6c
__dma_sync_single_for_cpu+0x34/0x6c
stmmac_napi_poll_rx+0x8f0/0xb60
__napi_poll.constprop.0+0x30/0x144
net_rx_action+0x160/0x274
handle_softirqs+0x1b8/0x1fc
...
To fix this, the PL bit-field in RDES3 register is used for all
descriptors, whether it is the last descriptor or not. |
| In the Linux kernel, the following vulnerability has been resolved:
can: ems_usb: ems_usb_read_bulk_callback(): check the proper length of a message
When looking at the data in a USB urb, the actual_length is the size of
the buffer passed to the driver, not the transfer_buffer_length which is
set by the driver as the max size of the buffer.
When parsing the messages in ems_usb_read_bulk_callback() properly check
the size both at the beginning of parsing the message to make sure it is
big enough for the expected structure, and at the end of the message to
make sure we don't overflow past the end of the buffer for the next
message. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: control: Validate buf_len before strnlen() in snd_ctl_elem_init_enum_names()
snd_ctl_elem_init_enum_names() advances pointer p through the names
buffer while decrementing buf_len. If buf_len reaches zero but items
remain, the next iteration calls strnlen(p, 0).
While strnlen(p, 0) returns 0 and would hit the existing name_len == 0
error path, CONFIG_FORTIFY_SOURCE's fortified strnlen() first checks
maxlen against __builtin_dynamic_object_size(). When Clang loses track
of p's object size inside the loop, this triggers a BRK exception panic
before the return value is examined.
Add a buf_len == 0 guard at the loop entry to prevent calling fortified
strnlen() on an exhausted buffer.
Found by kernel fuzz testing through Xiaomi Smartphone. |
| Missing Encryption of Sensitive Data vulnerability in Apache Tomcat due to the fix for CVE-2026-29146 allowing the bypass of the EncryptInterceptor.
This issue affects Apache Tomcat: 11.0.20, 10.1.53, 9.0.116.
Users are recommended to upgrade to version 11.0.21, 10.1.54 or 9.0.117, which fix the issue. |
| e107 is a content management system (CMS). Prior to 2.3.4, a Host Header Injection vulnerability in the password reset page allows attackers to manipulate the Host header to generate password reset links pointing to attacker-controlled domains. This can lead to phishing attacks, account takeover, or other security risks. The severity is high, as the vulnerability affects a critical function related to user authentication. This vulnerability is fixed in 2.3.4. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix potential out-of-bounds read in rtw_restruct_wmm_ie
The current code checks 'i + 5 < in_len' at the end of the if statement.
However, it accesses 'in_ie[i + 5]' before that check, which can lead
to an out-of-bounds read. Move the length check to the beginning of the
conditional to ensure the index is within bounds before accessing the
array. |
| In the Linux kernel, the following vulnerability has been resolved:
mtd: Avoid boot crash in RedBoot partition table parser
Given CONFIG_FORTIFY_SOURCE=y and a recent compiler,
commit 439a1bcac648 ("fortify: Use __builtin_dynamic_object_size() when
available") produces the warning below and an oops.
Searching for RedBoot partition table in 50000000.flash at offset 0x7e0000
------------[ cut here ]------------
WARNING: lib/string_helpers.c:1035 at 0xc029e04c, CPU#0: swapper/0/1
memcmp: detected buffer overflow: 15 byte read of buffer size 14
Modules linked in:
CPU: 0 UID: 0 PID: 1 Comm: swapper/0 Not tainted 6.19.0 #1 NONE
As Kees said, "'names' is pointing to the final 'namelen' many bytes
of the allocation ... 'namelen' could be basically any length at all.
This fortify warning looks legit to me -- this code used to be reading
beyond the end of the allocation."
Since the size of the dynamic allocation is calculated with strlen()
we can use strcmp() instead of memcmp() and remain within bounds. |
| The GDPR cookies module for Backdrop CMS (before
1.x-1.3.5) doesn't sufficiently protect visitors from Cross Site Scripting (XSS) if a malicious value has been provided for the optional 'Info content' field for the YouTube service. This is mitigated by the fact that an attacker must have a role with the permission "Create a GDPR Cookies Service" or "Edit any GDPR Cookies Service" and a site must have added a YouTube service as configuration. |
| Improper Neutralization of Script-Related HTML Tags in a Web Page (Basic XSS) vulnerability in SpabRice Nyla allows Code Injection.
This issue affects Nyla: from n/a through 1.7. |
